![]() Just click on the Hardware setting button and choose the swap options that suits your needs:Īfter pressing the OK button the new settings will be written to the touch controller. ![]() This can be done in the eGalaxTouch utility under the Hardware tab: you move the finger to the right but the cursor moves to the left) you can swap the respective coordinate (X/Y). If it only responds reversely on a coordinate axis (e.g. ![]() This should resolve most of the issues related to wrong response of the touchscreen. Then you have to successively touch four markings at the edges of the touchscreen, each for some seconds until it becomes green: Just run the eGalaxTouch utility (Configure Utility) and under the Tools tab choose the 4 Points Calibration : In general for wrong or reverse response of the touchscreen you can perform a calibration of it. ![]() The touchscreen controller will be listed in the device manager under "Mice and other pointing devices": Especially under Windows 10 there is by default a generic driver installed that lacks the touchscreen utility. PPNMX_eGalaxTouch_5.5_ZPE.exe) is installed or not. At first check whether the correct eGalax touchscreen driver (e.g.
0 Comments
Leave a Reply. |